Siemens SINUMERIK 808D ADVANCED Parameter Manual page 42

Machine data
3.2 General machine data
Means that there is no stop in any user ASUB block. Exception: The single block stop
has been explicitly activated via the SBLON command.
There are three different internal ASUBs that are triggered by different events.
- Repos: In the case of the events: change of operating mode to a manual mode (JOG,
JOGREF,...) unless MODESWITCH_MASK is not set, switch skip block on and off, activate
machine data, switch-on overstore, axis replacement, subroutine level cancelation,
switch-on single block, switch dry run feedrate on and off, alarm with compensation
block.
- Return: Delete distance-to-go, switchover after TEACH-IN (if available), or
deselection of MDI with corresponding MODESWITCH_MASK.
Bit16=1
Activating SERUPRO (search run via prog test) prevents stopping at single blocks.
Related to:
MD20117 $MC_IGNORE_SINGLEBLOCK_ASUP
10704 DRYRUN_MASK
- Dry run feedrate activation
-
- -
Description:
DRYRUN_MASK == 0
Dryrun can only be switched on or off at the end of the block.
When DRYRUN_MASK = 1 is set, the dry run feedrate can also be activated during program
execution (in the part program block).
NOTICE!
After activating dry run feedrate, the axes are stopped for the duration of the
reorganization process.
DRYRUN_MASK == 2
Dryrun can be switched on or off in every phase and the axes are not stopped.
NOTICE:
However, the function does not become active until a "later" block in the program
execution and this is with the next (implicit) StopRe block.
Related to:
SD42100 $SC_DRY_RUN_FEED
10706 SLASH_MASK
- Activation of block skip
-
- -
Description:
If SLASH_MASK = 0, skip block can only be activated when stopped at the end of the block
If SLASH_MASK = 1, skip block can also be activated during program execution.
NOTICE!
After activating skip block, the axes are stopped for the duration of the
reorganization process.
If SLASH_MASK = 2 ,skip block can be activated in every phase.
Notice!
However, the function does not become active until a "later" block in the program
execution, and this is with the next (implicit) StopRe block.
42
0 0
0 0
N01 V1
BYTE PowerOn
2 1/1
N01 PG, A2
BYTE PowerOn
2 1/1
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual