Siemens SINUMERIK 808D ADVANCED Parameter Manual page 16

Explanation of machine data and setting data
2.1 Data in the list
For the function areas listed below, the input and modification of data depends on the protection
level you have set:
● Tool offsets
● Work offsets
● Setting data
● RS232 settings
● Program creation / program correction
You can set the protection levels for these function areas through the following key operations
(USER_CLASS...):
Protection levels: 1, 3
Both of the two access levels require a password.
You can change the password only after an activation with the protection level 1.
If you forget your password, you can carry out a start-up through the following operations (with
the manufacturer password):
This will reset all passwords to their defaults according to the software release you have
acquired.
Note
Before performing a start-up with default data, you must backup your data; otherwise, you will
have your data lost.
16
+ → →
1. Select the desired operating area.
+
2. Press this softkey to enter the main screen of start-up.
3. Press this softkey to enter the main screen of NC start-up.
4. Use the cursor keys to select the second start-up mode.
5. Press this softkey to confirm your selection.
→ →
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual