Siemens SINUMERIK 808D ADVANCED Parameter Manual page 41

Reorganize is an internal procedure that is needed for mode change after JOG/
JOGREF..., switch skip block on and off, activate machine data, axis replacement,
switch on overstore, switch on single block, switch dry run feedrate on and off,
subroutine level cancelation, user ASUBs delete distance-to-go, switchover after TEACH-
IN (if available). Reorganize is never needed in Reset state.
Example blocks in which reorganize is impossible:
●
Tool change
●
1st block after the Repos procedure
●
Block after an ASUB from JOG/canceled
Bit7 = 1
Means that there cannot be a stop in any block in which repositioning is impossible.
Reposition is an internal procedure that is needed for mode change after JOG/
JOGREF..., switch skip block on and off, activate machine data, axis replacement,
switch on overstore, switch on single block, switch dry run feedrate on and off,
subroutine level cancelation, and possibly user ASUBs. Reposition is never needed in
Reset state.
Example blocks in which reposition is impossible:
- G33 + blocks in which reorganize is impossible.
Bit8 = 1
Means that there is no stop in a residual block that does not contain traversing
information.
Bit9 = 1
Means that there is no stop in a run in/main run synchronization block (e.g.STOPRE,
$Variable) that is repeated because of an interruption with Reorg (e.g. mode change).
Bit10= 1
Means that there is no stop in a "tool selection block". "Tool selection block" only
occurs with tool management (magazine management or TMMG) active. This block gives the
corresponding tool change command to the PLC.
This block is generally generated by T programming from the part program.
Example block "N1010 T="Drill" M6 D1"
Depending on machine data, the "tool selection block" can be held in the interpolator
until the PLC has acknowledged the corresponding tool change (see MD20310
$MC_TOOL_MANAGEMENT_MASK). However the program status remains in "run".
Bit11= 1
The control has to automatically generate implicit GET blocks for the axis replacement
function (axis replacement: 2 or more channels control one axis alternately) if no
explicit GET(D) has been programmed and the following block wants to traverse the
axis. (The other channel had previously used this axis).
An explicitly programmed GET may appear as follows "getd(x1,y1,z1) or get(x1,y1,z1)".
There is no stop at explicit or implicit GET blocks in the single block with this bit
11.
Bit12= 1
There is no stop in the single block type 2 in the SBLON block.
Bit13= 1
If an axis is pulled out in the middle of a block and possibly assigned to another
channel, then there is no stop at
a REPOSA in order to traverse it to the end, there is no stop until this end has been
reached.
Bit14=1
In a part program line, in which a substitution subroutine is called due to NC language
replacement, only one stop is performed under the condition that the subroutine
includes PROC attribute SBLOF. It is irrelevant whether the subroutine is called at
block start and/or end or whether it is exited with M17 or RET.
Bit15=1
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
the PREMATURE end of this block. This block follows
Machine data
3.2 General machine data
41