Siemens SINUMERIK 808D ADVANCED Parameter Manual page 442

Detailed descriptions of interface signals
5.8 Axis / spindle-specific signals
DB390x
DBX2002.6
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
corresponding to ...
Note for the reader
DB390x
DBX2002.7
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
corresponding to ...
Note for the reader
DB390x
DBX2003.5
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Application
Special cases, errors, ... If the spindle is traversed after a positioning for already set "Spindle in posi‐
corresponding to ...
Note for the reader
442
Active spindle mode oscillation mode
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The spindle is in the oscillation mode if a new gear stage was defined using
the automatic gear stage selection (M40) or using M41 to M45 (IS "Change
gear stage" is set). The IS "Change gear stage" is only set if a new gear
stage is defined that is not the same as the actual gear stage.
IS "Active spindle control mode" (DB390x DBX2002.7)
IS "Active spindle positioning mode" (DB390x DBX2002.5)
IS "Change gear stage" (DB390x DBX2000.3)
Function Manual Basic Functions S1
Active spindle control mode
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
With the following function, the spindle is in the control mode:
Spindle direction of rotation input M3/M4 or spindle stop M5
IS "Active spindle oscillating mode" (DB390x DBX2002.6)
IS "Active spindle positioning mode" (DB390x DBX2002.5)
Function Manual Basic Functions S1
Spindle in position
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
Precondition for the output of IS "Spindle in position" is reaching the IS "Exact
stop fine". Additionally, the last programmed spindle position must have been
reached on the setpoint side.
If the spindle is already at the programmed position after a positioning, then
the signal "Spindle in position" is set.
The IS "Spindle in position" is always reset when withdrawing IS "Exact stop
fine".
The interface signal is processed exclusively with the function spindle posi‐
tioning. This includes:
● SPOS, SPOSA and M19 in the part program
● SPOS and M19 in synchronized actions
Spindle in position for the tool change.
If the tool change cycle is interrupted by the machine operator e.g. with NC
stop, NC stop axis plus spindle, mode stop etc., then the correct position to
which the spindle is to travel in the tool changer can be queried using the IS
"Spindle in position".
tion" signal, e.g. in the JOG mode, then this signal is deleted. If the spindle
returns to its original position in the JOG mode, then the signal "Spindle in
position" is set again. The last position selection is maintained.
DB390x DBX0.7 (exact stop fine)
Function Manual Basic Functions S1
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual