Siemens SINUMERIK 808D ADVANCED Parameter Manual page 394

Detailed descriptions of interface signals
5.7 Channel-specific signals
Corresponding to ...
Note for the reader
DB3300
DBX1.3
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB3300
DBX1.4
Edge evaluation: No
Signal state 1
Signal state 0
Application
Note for the reader
DB3300
DBX1.5
Edge evaluation: No
Signal state 1
394
SD41100 JOG_REV_IS_ACTIVE (JOG: Revolutional / linear feedrate)
SD42600 JOG_FEED_PER_REV_SOURCE
(control revolutional feedrate in JOG)
SD43300 ASSIGN_FEED_PER_REV_SOURCE
(revolutional feedrate for positioning axes / spindles)
MD32040 JOG_REV_VELO_RAPID (revolutional feedrate for JOG with
rapid traverse override)
MD32050 JOG_REV_VELO (revolutional feedrate for JOG)
Function Manual Basic Functions V1
Handwheel override active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The function "Handwheel override in AUTOMATIC mode" is active for the
programmed path axes.
Handwheel pulses of the 1st geometry axis function as a velocity override
over the programmed path feedrate.
The function "Handwheel override in AUTOMATIC mode" is not active for
the programmed path axes.
An active handwheel override is not active if:
● The path axes have reached the target position
● The distance-to-go is deleted by the channel-specific interface signal
DB21, ... DBX6.2 (delete distance-to-go)
● A RESET is performed.
Function Manual Basic Functions H2
Block search active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The block search function is active. It was selected and started from the
operator interface.
The block search function is not active.
The block search function makes it possible to jump to a certain block within
a part program and to start processing the part program from this block.
Function Manual Basic Functions K1
M2/M30 active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
NC block with M2 has been completely executed. If traversing motion is also pro‐
grammed in this block, the signal is only output when the target position has been
reached.
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual