Siemens SINUMERIK 808D ADVANCED Parameter Manual page 255

32910 DYN_MATCH_TIME
s Time constant of dynamic response adaptation
-
- 6
Description:
The time constant of the dynamic response adaptation of an axis has to be entered in
this MD.
Axes interpolating with each other but having different dynamic responses can be
adapted to the "slowest" control loop by means of this value.
The difference of the equivalent time constant of the "slowest" control loop to the
individual axis has to be entered here as the time constant of the dynamic response
adaptation.
The MD is only active if MD32900 $MA_DYN_MATCH_ENABLE = 1.
Related to:
MD32900 $MA_DYN_MATCH_ENABLE (dynamic response adaptation)
33050 LUBRICATION_DIST
mm, degrees Traversing path for lubrication from PLC
-
- -
Description:
After the traversing path defined in the MD has been covered, the state of the axial
interface signal "Lubrication pulse" is inverted, this can activate an automatic
lubrication device.
The traversing path is summated after Power on.
The "Lubrication pulse" can be used with axes and spindles.
Application example(s):
The machine bed lubrication can be carried out as a function of the relevant traversed
path.
Note:
When 0 is entered, the NC/PLC interface signal DB390x DBX1002.0 (Lubrication pulse) is
set in every cycle.
Related to:
NC/PLC interface signal DB390x DBX1002.0 (Lubrication pulse)
33100 COMPRESS_POS_TOL
mm, degrees Maximum deviation during compression
CTEQ
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
The value specifies the maximum permissible path deviation for each axis with
compression.
The higher the value, the more short blocks can be compressed into a long block.
Not relevant for:
Active programmable contour/orientation tolerance (CTOL, OTOL, ATOL)
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0.0, 0.0, 0.0, 0.0, 0.0, 0.0
0.0
1.0e8 0.0
0.1 1.e-9
0.1 1.e-9
0.1 1.e-9
0.1 1.e-9
0.1 1.e-9
0.1 1.e-9
3.4 Axis-specific machine data
A07 G1, K3, S3, A2, A3, G2, S1, V1
DOUBLE NEW CONF
- 1/1
A03, A10 A2, Z1
DOUBLE NEW CONF
- 3/3
A10 F2, B1, K1
DOUBLE NEW CONF
- 1/1
- 3/3
- 0/0
- 0/0
- 7/7
- 7/7
Machine data
255