Siemens SINUMERIK 808D ADVANCED Parameter Manual page 298

Machine data
3.4 Axis-specific machine data
Extended monitoring of the actual value difference is active.
An offset between master and slave axes occurring in tracking or BREAK_UP is taken into
account in the monitoring of the actual value difference.
Prerequisite: The gantry grouping must be rereferenced or resynchronized after control
startup.
Alarm 10657 is output if alarm 10563 occurs before Power OFF.
Bit 1 = 0:
Zero mark search direction of the slave axis analogous to MD 34010
Bit 1 = 1:
Zero mark search direction of the slave axis same as for master axis
Bit 2 = 0 :
Alarm 10655 "Synchronization in progress" is output
Bit 2 = 1
Alarm 10655 "Synchronization in progress" is not output
37500 ESR_REACTION
- Axial mode of "Extended Stop and Retract"
CTEQ
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Selection of the response to be triggered via system variable "$AN_ESR_TRIGGER".
0 = No response Reaktion (or only external response through synchronized action
programming of rapid digital outputs).
21 = NC-controlled retraction axis
22 = NC-controlled stopping axis
37510 AX_ESR_DELAY_TIME1
s Delay time ESR single axis
CTEQ
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
If, for example, an alarm occurs, the deceleration time can be delayed by means of this
MD, e.g. to allow in case of gear hobbing the retraction from the tooth gap first.
37511 AX_ESR_DELAY_TIME2
s ESR time for interpolatory deceleration of single axis
CTEQ
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
298
0 0
0 0
0 0
0 0
0 0
0 0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
EXP, A01, A10 M3, P2
BYTE NEW CONF
22 ReadOnly
22 ReadOnly
22 ReadOnly
22 ReadOnly
22 7/2
22 7/2
EXP, A01, A10 P2
DOUBLE NEW CONF
- ReadOnly
- ReadOnly
- ReadOnly
- ReadOnly
- 7/2
- 7/2
EXP, A01, A10 P2
DOUBLE NEW CONF
- ReadOnly
- ReadOnly
- ReadOnly
- ReadOnly
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual