Hsc Status Codes (Sts) - Allen-Bradley Micro800 General Instructions Manual

HSCApp settings versus PLSData settings
When the PLS function is enabled, relevant HSCApp settings are superseded by
the corresponding PLSData settings as shown in the following table.
HSCApp setting
HSCAPP.HpSetting
HSCAPP.LpSetting
HSCAPP.HPOutput
HSCAPP.LPOutput
PLSData parameters example
The following figure shows the PLSData parameters in the Variable Selector.

HSC status codes (STS)

The following table describes the codes that are used to indicate the execution
status of the HSC function block.
Status code Status description
0x00 No action taken (not enabled).
0x01 HSC execution successful.
0x02 HSC command invalid.
0x03 HSC ID out of range.
0x04 HSC configure error.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
High-Speed Counter (HSC) instructions
PLSData setting
HSCHP
HSCLP
HSCHPOutput
HSCLPOutput
Chapter 14
331