Allen-Bradley Micro800 General Instructions Manual page 329

LPOutput
Parameter
HSCApp.LPOutput
LPOutput (HSCApp.LPOutput) defines the state (1 = "on", 0 = "off ") of the
outputs on the controller when the low preset is reached. For more information
on how to directly turn outputs on or off based on the low preset, see
OutputMask.
You can configure the low output bit pattern during initial setup, or you can use
the HSC function block to load the new parameters while the controller is
operating.
HSCSTSInfo parameters example
The following image shows the HSCStsInfo parameters in the Variable Selector.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
High-Speed Counter (HSC) instructions
Data type User program access
UDINT read/write
Chapter 14
329