Rtc_Set - Allen-Bradley Micro800 General Instructions Manual

Chapter 15
Input/Output instructions

RTC_SET

Parameter
Enable
RTCEnable
RTCData
RTCPresent
RTCEnabled
RTCBatLow
Sts
410
RTC_SET sets RTC status or write RTC information.
Arguments
Parameter Data type
type
Input BOOL
Input BOOL
Input RTC
Output BOOL
Output BOOL
Output BOOL
Output USINT
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Description
Function block enable.
When Enable = TRUE, execute RTC set with the RTC info from input.
When Enable = FALSE, there is no read operation and output RTC data is invalid.
TRUE - To enable RTC with the RTC data specified.
FALSE - To disable RTC.
Note: This is ignored by Micro810 controllers and Micro820 controllers.
RTC data information: yy/mm/dd, hh/mm/ss, week.
This RTC data are ignored when RTCEnable = 0.
See RTC data type on page 409.
TRUE - RTC hardware is plugged in.
FALSE - RTC hardware is not plugged in.
TRUE - RTC hardware is enabled (timing).
FALSE - RTC hardware is disabled (not timing).
TRUE - RTC battery is low.
FALSE - RTC battery is not low.
The read operation status.
See RTC Set Status values on page 411