Chapter 15
Input/Output instructions
Parameter
MMCatalog
Series
Revision
UPValid
ModeBehavior
LoadAlways
LoadOnError
FaultOverride
MMPresent
392
For controllers using an SD card:
MMINFO data type
The following table describes the MMINFO data type parameters.
Data type
Description
MMCATNUM
The catalog number of the Memory Module.
Note: When using the MM_INFO instruction on controllers with an SD card, the
MMCatalog is "SD CARD".
UINT
The series of the Memory Module.
Note: When using the MM_INFO instruction on controllers with an SD card, the series is
0.
UINT
The revision of the Memory Module.
Note: When using the MM_INFO on controllers with an SD card, the revision is 0.
BOOL
User program valid (TRUE: Valid).
BOOL
Mode behavior (TRUE: Go to RUN on power up).
BOOL
Memory Module restore to controller always on power up.
BOOL
Memory Module restore to controller if power up with error.
BOOL
Override fault on power up.
BOOL
Memory Module is present.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015