Sys_Info Data Type - Allen-Bradley Micro800 General Instructions Manual

Parameter
BootMajRev
BootMinRev
Operating System Series
OSMajRev
OSMinRev
ModeBehaviour
FaultOverride
StrtUpProtect
MajErrHalted
MajErrCode
MajErrUFR
UFRPouNum
MMLoadAlways
MMLoadOnError
MMPwdMismatch
FreeRunClock
ForcesInstall
EMINFilterMod

SYS_INFO data type

The following table describes the SYSINFO data type.
Data type Description
UINT Boot Major Revision.
UINT Boot Minor Revision.
UINT Operating System Series:
0 indicates a series A device
1 indicates a series B device
UINT OS Major Revision.
UINT OS Minor Revision.
BOOL Mode Behavior (TRUE: Go to RUN on power up).
BOOL Fault Override (TRUE: Override error on power up).
BOOL Startup Protection (TRUE: Run startup protection program on power up).
Tip: For future release
BOOL Major error halted (TRUE: Major error halted).
UINT Major error code.
BOOL Major error during user fault routine.
Tip: For future release
UINT User fault routine program number.
BOOL Memory Module restore to controller always on power up (TRUE: Restore).
BOOL Memory Module restore to controller if power up with error (TRUE: Restore).
BOOL Memory Module password mismatch (TRUE: Controller and Memory Module password mismatch).
UINT Free running clock that increments every 100 microseconds from 0 to 65535 and then returns to 0. You can use the
Clock, which is globally accessible, if you need more resolution than the standard 1 millisecond timer.
Tip: Only supported for Micro830 and Micro850 controllers. Value for Micro810 controllers remains 0.
BOOL Forces enabled (TRUE: Enabled).
BOOL Embedded filter modified (TRUE: Modified).
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Chapter 15
Input/Output instructions
415