Using The High-Speed Counter Instructions; Updating Hsc Application Data - Allen-Bradley Micro800 General Instructions Manual

Using the High-Speed
Counter instructions
This section provides specific details and examples for using high-speed counter
instructions in logic programs, including the following:

Updating HSC application data

Configuring a High-Speed Counter (HSC) user interrupt
Configuring a Programmable Limit Switch (PLS)
Example: How to create a High-Speed Counter(HSC)
Example: How to add a Programmable Limit Switch (PLS) function
352
Example: Programmable Limit Switch (PLS) enabled
Updating HSC application data
HSC configuration is defined in the HSC application data, and is usually only
configured once before programming the HSC instruction. Changes made to the
HSC application data (HSCAppData parameter) are ignored while the HSC is
counting.
To update the HSC configuration
1. Update HSCAppData.
Call the HSC instruction with command 0x03 (set/reload).
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
High-Speed Counter (HSC) instructions
on page 335
on page 341
on
on
Chapter 14
on page 337
page 341
on page
page 354
335