Allen-Bradley Micro800 General Instructions Manual page 185

Arguments
Parameter Parameter
type
IN Input
CtrlCfg Input
SymbolicCfg Input
TargetCfg Input
Data Input
Q Output
Status Output
DataLength Output
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Data type Description
BOOL If Rising Edge (IN turns from FALSE to TRUE), start the function block with the
precondition that the last operation has been completed.
CIPCONTROLCFG Function block execution control configuration.
See CIPCONTROLCFG data type
CIPSYMBOLICCFG Information for the symbol to Read/Write.
See CIPSYMBOLICCFG data type
CIPTARGETCFG Target device configuration.
See CIPTARGETCFG data type
USINT[490] Read command stores the data returned from the server.
Write command buffers the data to be sent to the server.
When a MSG is triggered or retriggered, Data is cleared for the MSG Read
command.
See Supported Data Packet Size for CIP Serial Function
Tip: Refer to 2080-qs002_-en-e.pdf
BOOL Outputs of this instruction are updated asynchronously from the program scan.
Output Q cannot be used to re-trigger the instruction since IN is edge triggered.
FALSE - The function block is not done.
TRUE - The function block is done.
CIPSTATUS Function block execution status
When a MSG is triggered, or re-triggered, all elements inside Status are reset.
See CIPSTATUS data type
UDINT Number of data bytes Read/Written.
When a MSG is triggered or retriggered, DataLength is reset to 0 for MSG Read
command.
Communication instructions
on page 177.
on page 187.
on page 180.
on page 178.
Chapter 9
185