Cipstatus Data Type - Allen-Bradley Micro800 General Instructions Manual

Chapter 9
Communication instructions
Parameter
Error
ErrorID
SubErrorID
ExtErrorID
StatusBits
178
Example: message triggering
In the following example, the TriggerType value is set to 100.

CIPSTATUS data type

The following table describes the CIPSTATUS data type.
Data type Description
BOOL This bit is set to TRUE when the function block execution encounters an error condition.
UINT Error code value.
See CIPSTATUS error codes
UINT Sub Error code value.
See CIPSTATUS error codes
UINT CIP extended status error code value.
UINT This parameter can be used to verify control bits:
• Bit 0: EN – Enable
• Bit 1: EW – Enable Wait
• Bit 2: ST – Start
• Bit 3: ER – Error
• Bit 4: DN – Done
• Other bits are reserved
• See
CIPSTATUS status bits
MSG_CIPGENERIC
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
on page 179.
on page 179.
on page 178.
on page 174