Allen-Bradley Micro800 General Instructions Manual page 182

Chapter 9
Communication instructions
String example
"0,0"
"6,1"
"4,192.168.1.100"
"4,192.168.1.100,1,0"
Scenario
Message request is enabled and CipConnMode=1.
Message request is enabled, CipConnMode=1, and the message's local
port is Ethernet.
Message request is enabled, CipConnMode=0, and the message's local
port is Ethernet.
Message execution is completed, and ConnClose is set to True.
Message execution is completed, and ConnClose is set to False.
Connection is not associated with an active message, and remains idle
for the amount of time specified in ConnTimeOut parameter.
Controller transitions from an executing mode (Run, Remote Run,
Remote Test Single Scan and Remote Single Rung) to a non-executing
mode.
182
Target path example
The following table lists example values used in a target path string and describes
the results for each string.
Results
The target device is the local device.
Through Port 6 (Micro830 UPM Serial port) reach the Node at 1.
Through Port 4 (Micro850 embedded Ethernet port) reach the Node at 192.168.1.100.
Through Port 4 (Micro850 embedded Ethernet port) reach the Node at 192.168.0.100 (Logix ENET module).
From ENET module, through the Backplane port (Port 1) reach the Logix controller at Slot 0.
CIP/EIP message connections
A maximum of 16 CIP (class 3) and 16 EIP connections are supported for client
message execution. The following table describes the CIP/EIP connection
behavior.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Results
If a connection to the target does not exist, a CIP connection is established.
If a connection to the target already exists, the existing CIP connection is used.
If an EIP connection to the target does not exist, an EIP connection is established
prior to establishing a CIP connection.
If an EIP connection to the target does not exist, an EIP connection is established.
If there is only one connection to the target, the connection is closed.
If there is more than one connection to the target, the connection is closed when
the last message execution is completed.
When a CIP connection is closed, any associated EIP connection is also closed.
If more than one CIP connection uses the same EIP connection, the EIP connection
will be closed after all associated CIP connections are closed.
The connection is not closed.
The connection is closed.
All active connections are forcibly closed.