Allen-Bradley Micro800 General Instructions Manual page 343

Creating a High-Speed Counter (HSC) program
Perform the following tasks for to create, build, and test the HSC program, and
then add a PLS function.
No Task
1 Create a ladder diagram and add variables
2 Assign values to the HSC variables
3 Assign variables and build the program
4 Test the program and run the High-Speed Counter
5 Add a Programmable Limit Switch (PLS) function
Create a ladder diagram and add variables
Follow these steps to create a ladder diagram and then add local variables to the
rung. This sample program uses a 2080-LC50-24QVB controller. The HSC is
supported on all Micro830 and Micro850 controllers except 2080-LCxx-xxAWB
controller types.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
High-Speed Counter (HSC) instructions
on page 343
on page 347
on page 348
on page 350
on page 352
Chapter 14
343