Ascii Parameter Details; Abl Error Codes - Allen-Bradley Micro800 General Instructions Manual

ASCII parameter details

Error code Error description
02 Operation cannot be completed because the modem went offline.
03 Transmission cannot be completed because the Clear-to-Send signal was lost.
05 While attempting to complete an ASCII transmission, System Mode (DF1) communication was detected.
06 Illegal parameter was detected.
07 Cannot complete ASCII send or receive because channel configuration has been shut down via the channel configuration dialog box.
08 Cannot complete ASCII Write due to an ASCII transmission already in progress.
09 ASCII communication requested is not supported by current channel configuration.
10 The Cancel was set, stopping instruction execution. No action required.
11 The requested length for the string is either invalid, a negative number, greater than 82, or 0. Applies to
blocks.
13 The requested (.LEN) in the control block is a negative number or a value greater than the string size stored with the source string. Applies to
123 and AWT
14 The ACL on
15 The channel configuration mode was changed.
The following topics provide additional details for ASCII parameters and
structured data types.

ABL error codes

ABLACB data type
ACL data type
AHL ChannelSts data type
AHLI data type
ARDARL data type
AWAAWT data type
ABL error codes
The following table describes ABL error codes.
on page 125 function blocks.
page 114 function block was aborted.
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
on page 127
on page 127
on page 128
on page 128
on page 129
on page 129
on page 130
ASCII serial port instructions
ARD on page 118 and ARL on page 121
AWA
Chapter 6
function
on page
127