Ciptargetcfg Data Type - Allen-Bradley Micro800 General Instructions Manual

ErrorID SubErrorID
code
255 Channel is shutdown or reconfiguration is in progress. Error code occurs immediately after power on until a connection is established, and is
normal behavior.
It may also occur in one of the following situations:
• An Ethernet cable is disconnected
• An IP address cannot be detected
• A serial port plugin is present but not configured
Parameter Data type
Path STRING[80]
CipConnMode USINT
UcmmTimeout UDINT
ConnMsgTimeout UDINT
ConnClose BOOL
Error code description

CIPTARGETCFG data type

The following table describes the CIPTARGETCFG data type.
Description
Path for the target. A maximum of two hops can be specified. The path syntax is:
• {"<port>,<node/slot address>"}2
See also Target path for CIP messaging
CIP Connection type.
• 0 - Unconnected (default)
• 1 - Class3 connection
See also CIP/EIP message connections
Unconnected message timeout (in milliseconds). The amount of time to wait for a reply for unconnected
messages, including connection establishment for connected message.
• Valid values: 250-10,000.
• Set to 0 to use the default value of 3000.
• A value set to less than 250 will be set to 250 (minimum).
• A value set to greater than 10,000 will be set to 10,000 (maximum).
See also CIP message timeout timers
Class3 Connection timeout (in milliseconds). The amount of time to wait for a reply for connected messages. The
connection closes when the timeout expires.
• Valid values: 800-10,000
• Set to 0 to use the default value of 3000
• A value set to less than 800 will be set to 800 (minimum)
• A value set to greater than 10,000 will be set to 10,000 (maximum)
See also CIP message timeout timers
Connection closing behavior:
• TRUE - Close the connection when the message completes.
• FALSE - Do not close the connection when the message completed (default).
• See also
CIP/EIP message connections
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Communication instructions
on page 181.
on page 182
on page 183.
on page 183100.
on page 182.
Chapter 9
193