Instruction Set In Alphabetical Order - Allen-Bradley Micro800 General Instructions Manual

Instruction set in
alphabetical order
Defining function block and parameter names
The interface of a function block must be explicitly defined with a type and a
unique name for each of its calling (input) parameters or return (output)
parameters. Function blocks can have more than one output parameter. The value
of a return parameter for a function block is different for each programming
language (FBD, LD, ST).
Function block names and function block parameter names can use up to 128
characters. Function block parameter names can begin with a letter or an
underscore followed by letters, numbers, and single underscores.
The following table lists the instruction set available in Connected Components
workbench in alphabetical order.
Instruction
ABL on page 110
ABS on page 62
ACB on page 111
ACL on page 114
ACOS on page 64
ACOS_LREAL on page 66
Addition on page 68
AHL on page 116
AND on page 157
AND_MASK on page 132
ANY_TO_BOOL on page 278
ANY_TO_BYTE on page 279
ANY_TO_DATE on page 280
ANY_TO_DINT on page 281
ANY_TO_DWORD on page 282
ANY_TO_INT on page 282
ANY_TO_LINT on page 284
ANY_TO_LREAL on page 285
ANY_TO_LWORD on page 286
ANY_TO_REAL on page 287
ANY_TO_SINT on page 288
ANY_TO_STRING on page 289
ANY_TO_TIME on page 290
ANY_TO_UDINT on page 291
ANY_TO_UINT on page 292
ANY_TO_ULINT on page 292
ANY_TO_USINT on page 294
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Finding information about instructions and ladder elements
Instruction block type
Function block
Function
Function block
Function block
Function
Function
Operator
Function block
Operator
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Function
Chapter 1
19