Test And Diagnostic Information-Model Z03; Printing The Printer Demonstration; Printing The Firmware Part Number And Version Levels; Printing The Printer Configuration And The Custom Sets - InfoPrint 4247 Z03 Maintenance Information

Test and diagnostic information—Model Z03

Printing the printer demonstration

1. Power off the printer.
2. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor and forms path the
customer is using.
3. Power on the printer.
4. Press the STOP key to make the printer Not Ready.
5. Press the TEST key. The message OPERATOR PRINT TESTS appears.
6. Press the SCROLL/MICRO ↓ key until the Printer Demonstration test is displayed below OPERATOR PRINT
TESTS.
7. Press the ENTER key, and wait for the test to finish.
8. Press the CANCEL PRINT (or RETURN) key to exit test mode.

Printing the firmware part number and version levels

1. Power off the printer.
2. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor and forms path the
customer is using.
3. Power on the printer.
4. Press the STOP key to make the printer Not Ready.
5. Press the TEST key. The message OPERATOR PRINT TESTS appears.
6. Press the SCROLL/MICRO ↓ key until the Firmware Information test is displayed below OPERATOR PRINT
TESTS.
7. Press the ENTER key, and wait for the firmware part number Controller, and Attachment Code versions to
print.
8. Press the CANCEL PRINT (or RETURN)key to exit test mode.

Printing the printer configuration and the custom sets

It is possible to store up to 8 custom configurations. The current printer configuration is shown on the operator
panel display in the upper right corner as <X>.
85
Chapter 2. Diagnostics