Automatic Forms Thickness Adjust (Afta) Assembly - InfoPrint 4247 Z03 Maintenance Information

Automatic forms thickness adjust (AFTA) assembly

Perform the following procedures first:
1. Remove the Rear cover and metal protector.
2. Remove the Cover group.
Then:
3. Record the AFTA indicator setting.
4. Disconnect the AFTA motor connector from the Engine board (see Figure 8 in Chapter 4, "Locations").
5. Remove the cable from the cable retainers located in the rear part of the mechanical asm.
Note the location of the connector and the cable path.
AFTA Motor
Screws
AFTA
Indicator
Screws
6. Remove the 2 AFTA motor screws and remove the motor.
If the motor is being removed only to access other parts, do
not disconnect the connector.
7. Remove the 2 AFTA indicator mounting screws and remove
the indicator.
Chapter 5. Removals, service checks and adjustments
194