Table of Contents
Advertisement
Ribbon drive motor and drive assembly
CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes for parts in this area to cool before
handling.
Perform the following procedures first:
1. Turn off the power and disconnect the power cord.
2. Remove the Rear cover.
3. Remove the Cover group.
4. Remove the Engine board and power supply metal protector.
Then:
5. Remove the ribbon.
6. Disconnect the ribbon motor cable connector from the Engine board (see Figure 8 in Chapter 4, "Locations"). Note the location of
the connector and the cable path to aid installation.
If the motor is being removed only to access other parts, do not disconnect the connector.
7. Remove the ribbon motor mounting screws and remove the
ribbon drive motor. Note the type and location of each screw
to aid installation.
Chapter 5. Removals, service checks and adjustments
223
Advertisement
Chapters
Table of Contents
