InfoPrint 4247 Z03 Maintenance Information page 98

Continue with "Calibrate the microcode."
For the two tractor installed configuration the display is:
T&D10 AFTA CALIBRATE
USER REAR FF? YES
If YES:
T&D10 AFTA CALIBRATE
LOAD PAPER
Load 20 lb (80 g/m²) fanfold paper in rear (lower) tractor and press SET TOP OF FORM to execute calibration
using fanfold forms.
If NO:
T&D10 AFTA CALIBRATE
INSERT SING. SHEET ON UP
Manually load a single sheet of 20 lb (80 g/m²) paper into the upper paper path. Locate the hole in the Base
frame and black taped area of the Guide Assembly. Insert paper into this area of the upper tractor path.
(Approximately 4 1/2 inches inboard from the left edge of the tractor assembly.)
Continue with "Calibrate the microcode."
Calibrate the microcode: Place 20 lb (80 g/m²) paper in the appropriate paper path.
Display:
T&D10 AFTA CALIBRATE
PAPER +
NO
RUN −
98
Chapter 2. Diagnostics