Table of Contents
Advertisement
11. Close the FTP connection by typing the command: bye <enter>. After the FTP session is closed the file
update will start.
12. After the code update completes, the printer automatically reboots and STARTING UP displays.
13. Printout the printer configuration menus again and label them "new". Compare the new printout to one the old
printout, and restore the old menu settings as needed.
Note: The new code version level also prints out.
Error messages
INVALID CODE: Binary code file is corrupt or incompatible.
ERROR RECOVERY ACTION: Open the Windows (Generic/Text only) print driver queue, cancel all pending print
documents, and try again. If the error repeats the code file may be corrupted or incompatible with this printer
model. After displaying this message, the printer automatically discharges any code upgrade and escapes from
the firmware downloading procedure returning in normal ON LINE status.
FILE NOT FOUND: Code file cannot be found by DOS.
ERROR RECOVERY ACTION: Change the path in the DOS window to the directory where the code file is
located.
1. For models X03 and Z03 printers, code is not compatible between the two printers, that is, the X03 code may not be installed on a
Z03 Controller Board or Z03 code on an X03 Controller Board.
1
Appendix C. Firmware Downloading
295
Advertisement
Chapters
Table of Contents
