Ribbon Feed And Ribbon Lift Service Check - InfoPrint 4247 Z03 Maintenance Information

Ribbon feed and ribbon lift service check

You are here because of an 089 RIBBON JAM message or any of the other symptoms in MAP 0160.
1. Open the top cover and remove the ribbon.
2. Advance the ribbon by turning the knob in the direction of the arrow. The ribbon should freely advance
without the ribbon folding over. Replace the ribbon cartridge if you locate a problem such as a ribbon that
binds or is folded over.
Figure 22. Ribbon carriage and ribbon brackets. (Viewed from top left)
3. Inspect the left ribbon bracket for wear, damage, or binds. Repair the following parts, as needed:
v Ribbon feed spool tabs
v Ribbon motion sensor
v Ribbon spool teeth
Note: The ribbon feed spool has three tabs on the bottom that interrupt the ribbon motion sensor.
Chapter 5. Removals, service checks and adjustments
168