Table of Contents
Advertisement
Operator panel
1. Power off the printer and remove the power cord.
2. Open the front cover.
3. From inside and under the top, press inward on the left tab on
the operator panel bracket and loosen it from the support.
Attention:
Be careful not to pull the wire leads from the
Attention Light Connector.
4. Disconnect the attention light connector and the operator
panel connector from the operator panel.
5.
Remove the operator panel.
Note the location of the connectors and the cable paths.
Attention:
The operator panel cable assembly uses a splice
connector/cable to increase its length. Be sure to properly
connect the splice connector or damage to the operator panel will
occur on power up.
Chapter 5. Removals, service checks and adjustments
211
Advertisement
Chapters
Table of Contents
