InfoPrint 4247 Z03 Maintenance Information page 54

Table 7. MAP 0160: Ribbon feed and ribbon lift (continued)
Step Questions/Actions
Does the ribbon motor run continuously?
3.
Perform the ribbon service check (see Ribbon feed and
4.
ribbon lift service check).
Is the service check OK?
Ensure that a ribbon is installed.
5.
Run T&D09 in single test mode to test ribbon feed and lift
(see Running the test and diagnostic (T&D) programs).
Does the ribbon feed OK?
Did the ribbon lift OK?
6.
Yes
Install a new Engine board
(see Engine board).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Go to step 5.
Go to step 6.
Return to the step that sent
you to this MAP.
No
Go to step 4.
Repair as needed.
Go to step 7.
Go to step 8.
Chapter 1. Diagnosing problems
54