Encoder Board - InfoPrint 4247 Z03 Maintenance Information

Encoder board

CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes for parts in this area to cool before
handling.
Attention: This is an ESD sensitive area. See Electrostatic discharge (ESD) procedures before working with
parts that are sensitive to ESD.
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Cover group.
3. Remove the Printhead.
Do not remove the printhead cables yet.
Then:
Attention: Use care not to scratch the encoder strip in this step.
4. Remove the 3 screws holding the encoder strip, and carefully
remove the encoder strip.
Chapter 5. Removals, service checks and adjustments
204