Table of Contents
Advertisement
Table 11. Error messages (continued)
Message
053 MACHINE CHECK 40X
053 MACHINE CHECK 41X
053 MACHINE CHECK ERR 43X
054 MACHINE CHECK
055 MACHINE CHECK
056 MACHINE CHECK
068 DATA CLEARED
PRESS STOP THEN START
070 PRINTER BOARD CHANGED
VERIFY MENU SETTINGS
086 INTERLOCK ERROR
CHECK INSERTION (Model X03 only)
Description
Firmware error detected during initialization
of ribbon motion sensor.
Firmware error detected during initialization
of printhead.
Power on initialization error
AFTA failure.
The printhead encoder has detected an
error in the location or motion of the
printhead carriage.
Clear command received when the printer
was not ready.
Occurs when printer Engine board or
microcode version has been replaced.
Small Rear Cover Interlock not being
detected.
Action
Turn off and then turn on the printer. If
message remains, see MAP 0160: Ribbon
feed and ribbon lift.
Turn off and then turn on the printer. If
message remains:
1. Ensure no paper or debris is blocking
the printhead encoder.
2. Ensure all Engine board connectors are
connected.
3. See MAP 0140: Printhead drive.
1. Power off the printer, reseat the
Controller Board, and power on.
2. If the error message repeats, replace
the Controller Board.
Turn off and then turn on the printer. If
message remains, see MAP 0200: 055
AFTA errors.
Turn off and then turn on the printer. If
message remains, see MAP 0140:
Printhead drive.
Press STOP, then START.
Verify printer configuration settings and
Custom Sets.
Turn the power off. Ensure the Small Rear
Cover is properly installed. Turn the power
on.
Chapter 1. Diagnosing problems
75
Advertisement
Chapters
Table of Contents
