T&D12-Bidirectional Adjustment Test - InfoPrint 4247 Z03 Maintenance Information

7. Press the SET TOP OF FORM key.
8. The following message will be displayed:
T&D11 FIRST LINE ADJ TST
STORE
9. A line of Es will be printed on the first printing line, and then the paper will feed to a position for
viewing. The Es should be completely on the paper. The top of the Es should be approximately 1 mm
(0.04 in.) below the perforation.
10. If the first print-line adjustment is correct, press the SET TOP OF FORM key to store the first print-line
position. If the optional tractor is installed, load the paper in the optional tractor and repeat the above
procedure to adjust the first print line for that tractor.
11. If the first print-line adjustment is not correct, press the LOAD/EJECT key to get the next display.
T&D11 FIRST LINE ADJ TST
FRONT (n) +
12. Press the SET TOP OF FORM key once to increase the space between the top of the form and the
top of the print test, or press the LOAD/EJECT key once to decrease the space between the top of
the form and the top of the print test. The value changes on the operator panel display.
13. Press the CANCEL PRINT key to run the test.
14. Go to T&D11 step 9, and repeat until the line of Es is just below the edge of the form.
15. To exit this test without adjusting the optional second tractor first print-line, press the LOAD/EJECT
key.
16. If an error message is displayed, go to T&D error messages and actions.
17. The test completed successfully if the present test is displayed again. Press the LOAD/EJECT key to
skip to the next test.
T&D12—Bidirectional adjustment test
Note: This test allows the bidirectional adjustment to be made from the operator panel.
YES NO
RUN -
101
Chapter 2. Diagnostics