First Line Printing; Paper Feed Belt; Service Check; Adjustment - InfoPrint 4247 Z03 Maintenance Information

First line printing

This adjustment uses T&D11 to locate the first print-line, using the operator panel.

Service check

The Vert and Load values should be zero, and the first line on the print test should be below the perforation.

Adjustment

1. Run the T&D program in single test mode.
v See Running the test and diagnostic (T&D) programs.
2. Scroll to T&D11

Paper feed belt

Service check
1. Turn off the printer.
2. Remove the printer covers (see Service position).
3. Remove the rear (default) tractor assembly.
4. Use a push-pull scale (P/N 44D9056, or equivalent) to push on the lever to verify that the tension on the belt
is between 0.55 and 0.75 kg (1.2 - 1.6 lb).
Chapter 5. Removals, service checks and adjustments
154