InfoPrint 4247 Z03 Maintenance Information page 46

Table 5. MAP 0140: Printhead drive (continued)
Step Questions/Actions
Disconnect the 26-conductor printhead cable from the
6.
Engine board (see Chapter 4, "Locations," on page 133).
See Printhead cable wiring to measure the resistance of pin
5 end-to-end and pin 6 end-to-end.
Is the resistance 5 ohms or less for both pins?
Yes
Reinstall the printhead.
Carefully follow the
replacement procedure,
"Printhead" on page 220.
Install a new carriage motor
(see Carriage drive motor
assembly and fan).
- or -
Install a new Engine board
(see Engine board).
- or -
Install a new encoder board
(see Encoder board).
- or -
Install a new encoder board
strip (see Encoder board).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs.
No
Install new printhead cables.
Re-install the printhead.
Carefully follow the
replacement procedure (see
Printhead).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Chapter 1. Diagnosing problems
46