T&D13-Tear-Off Line Adjustment Test - InfoPrint 4247 Z03 Maintenance Information

9. If the bidirectional adjustment printout is correct, press the SET TOP OF FORM key to store the value.
10. If the bidirectional adjustment printout is not correct, press the LOAD/EJECT key to enter a change to
vertical adj. value:
T&D12 BIDIR. ADJ. TEST
VERT. (n) +
11. Press the SET TOP OF FORM key once to shift the bottom row of Is to the right, or the LOAD/EJECT
key to shift the bottom row of Is to the left. The value changes on the operator panel display.
12. Press CANCEL PRINT to execute the vertical adjustment test and to print the selected pattern.
13. If an error message is displayed, go to T&D error messages and actions.
14. If satisfied with the results, press the SET TOP OF FORM key to store the values. The display shows:
T&D12 BID. ADJ TEST
TEAR & PUSH KEY
Tear output and press any key to perform that action.
Press the LOAD/EJECT key to skip to the next test.
T&D13—Tear-off line adjustment test
This test allows you to adjust the tear-off position from the operator panel. Load fanfold paper into the appropriate
tractor(s).
The value set by this test becomes the tear-off position when the configuration menu item Tear Adjustment is set
to 0 at the operator panel.
1. Display:
T&D13 TEAR-OFF LINE ADJ
RUN TEST?
2. Press SET TOP OF FORM to execute test. Press LOAD/EJECT to skip test.
RUN -
YES NO
103
Chapter 2. Diagnostics