Table of Contents
Advertisement
Cover group:
Perform the following procedure first:
1. Remove the Rear cover.
Then:
2. Remove 3 screws from each side.
Option: You may want to remove the operator panel first. To
remove the Operator Panel, follow steps 3 through 5.
3. From inside and under the top, press inward on the left tab on
the operator panel bracket and loosen the operator panel from
the support.
4. Disconnect the attention light connector and the operator
panel connector from the operator panel.
5. Remove the operator panel.
Note: If you chose not to remove the operator panel, you
must still remove the operator panel connector and perform
step 6.
6. Detach the operator panel cable and connector from any
cable path bracket on the under side of the cover group.
Chapter 5. Removals, service checks and adjustments
183
Advertisement
Chapters
Table of Contents
