InfoPrint 4247 Z03 Maintenance Information page 68

Table 9. MAP 0190: Forms feed problems (continued)
Step Questions/Actions
A paper presence sensor failure can cause an 099 forms jam
19.
message to display after a Park or Eject operation.
Did a Park or Eject operation cause the error message?
Check the sensor cable assembly for wear or damage.
20.
Is it OK?
Yes
Run T&D18, including
performing a sensor tune, and
verify correct sensor
operation. If not OK:
v Install a new Engine board
(see Engine board).
v If the printer is still failing
after the Engine board has
been changed, install a new
sensor assembly cable (see
Sensor cable assembly).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Install a new Engine board.
Run T&D in automatic test
mode to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
No
Go to step 20.
Install a new sensor cable
assembly.
Run T&D in automatic test
mode to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Chapter 1. Diagnosing problems
68