Table of Contents
Advertisement
IF the Default Tractor and optional Second Tractor are installed, the printer displays:
T&D13 TEAR-OFF LINE ADJ
REAR ADJ?
To adjust the tear-off line for the front tractor feed (when optional tractor is installed), press the LOAD/EJECT
key and the tractor feed will switch to the front.
If only the default tractor is installed, the printer displays:
T&D13 TEAR-OFF LINE ADJ
FRONT ADJ?
3. With the appropriate tractor feed (Front or Rear) selected, press SET TOP OF FORM to run the test.
4. The procedure to adjust either front or rear tear-off line is the same.
5. A line of Xs will be printed on the first print-line. The paper will feed to the tear-off bar for viewing. The Xs
should be completely on the paper. The top of the Xs should be approximately 1 mm (0.04 in.) below the
perforation. If this condition does not exist, perform T&D11—First line adjustment test, and then return here.
6. The following message displays:
T&D13 TEAR-OFF LINE ADJ
REAR. (n)
+
RUN
7. Figure 6 shows the correct position of the perforation for a clean tear-off.
YES
NO
YES
NO
-
104
Chapter 2. Diagnostics
Advertisement
Chapters
Table of Contents
