Lower Plastic Shield/Lower Mylar - InfoPrint 4247 Z03 Maintenance Information

Lower plastic shield/lower mylar

1. Open the top cover and remove the ribbon cartridge.
2. Remove the bail assembly.
3. Remove the screw on each end of the plastic shield
assembly.
4. Remove the lower plastic shield assembly by sliding it
between the mask and the platen. To simplify this operation,
move the AFTA marker in order to put the printhead at the
furthest position from the platen.
Installation notes: Follow the removal steps in reverse order
being careful not to damage the printhead mask.
Chapter 5. Removals, service checks and adjustments
210