InfoPrint 4247 Z03 Maintenance Information page 170

Ribbon Lift
Motor Screws
Ribbon Lift Motor
Connector
Figure 24. Ribbon lift motor. (Viewed from top)
9. Ensure that the printhead cables are connected at both ends correctly.
10. Install the ribbon cartridge.
11. Perform T&D09 Verify that the ribbon is driven up and down by the ribbon lift motor and pulled to the left by
the ribbon feed motor.
12. Return to the step that sent you here.
Note: If the ribbon lift motor lifts and lowers the ribbon during T&D09, but not during printing, the cause might be
a faulty Controller board. Replace the Controller board.
Printhead
Printhead
Cable
Chapter 5. Removals, service checks and adjustments
170