Printing And Clearing The Error Log, And Printing The Usage Metrics - InfoPrint 4247 Z03 Maintenance Information

1. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor the customer is using.
2. Press the STOP key to make the printer Not Ready.
3. Press the TEST key. The message OPERATOR PRINT TESTS appears.
4. Press the SCROLL/MICRO ↓ key until the Printer Configuration test is displayed below OPERATOR PRINT
TESTS.
5. Press the ENTER key, and wait for the configuration to print. To print a custom set:
a. Press the SCROLL/MICRO ↓ key until Print Custom Sets is displayed.
b. Press the ENTER key and wait.
6. Press the CANCEL PRINT (or RETURN) key to exit test mode.

Printing and clearing the error log, and printing the usage metrics

Error Log: When a previously not logged error is encountered during printer operation, the Code Description is
entered into the Print Error Log and the Count is set to 00001. If the Code Description existed in the error log
from a previous posting, the Count is incriminated to the next higher number (see Figure 3).
The Print Error Log has a maximum capacity of 8 Code Description entries. If fewer than 8 Code Descriptions are
encountered, the unused entries remain at zero. When a ninth Code Description is encountered, the oldest entry
is deleted from the Print Error Log, and the new entry is included in the list. Stated another way, only the 8 most
current errors are maintained in the Print Error Log.
The maximum Count that will register for an Error is 256.
Print Usage Metrics:
The test prints decimal values for the following data:
v Power-on hours
v Power-on cycles
v Fast Draft, DP, DP text, and NLQ characters
v Number (quantity) of barcodes
v Number (quantity) of pages with graphics or images
86
Chapter 2. Diagnostics