Sensor Cable Assembly - InfoPrint 4247 Z03 Maintenance Information

Sensor cable assembly

Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Cover group.
Then:
Base
Tractor
Second
Tractor
Ribbon Motion
3. Remove the ribbon drive motor and left ribbon cartridge
support (see "Ribbon drive motor and drive assembly" on
page 223).
4. Remove the upper feed roller assembly (see Upper feed roller
shaft assembly).
5. Remove the platen assembly (some steps are completed)
(see Platen assembly).
6. Disconnect the sensor cable connector from the Engine board
(see Figure 8 in Chapter 4, "Locations").
Note the location and path of the cable.
7. Remove the screws for each of the 3 sensors and remove the
cable assembly.
Installation notes
Perform the following:
1. Sensor service checks
2. Print Head Gap Service Checks
3. First line printing
Chapter 5. Removals, service checks and adjustments
228