Other Considerations For Forms - InfoPrint 4247 Z03 Maintenance Information

Table 23. Choosing a forms path for special forms (continued)
Function
2
Second tractor (optional, becomes front tractor)
Second tractor (optional, becomes front tractor)
This tractor can be installed in front of the base tractor as an option. In a two tractor machine the second (optional) tractor is the
front tractor and the base tractor becomes the rear tractor.
The 4247 Model Z03 printer does not support the following types of forms:
v Greater than 8-part
v Greater than 40 lb paper
v Greater than 0.64 mm (0.025 in.) total forms thickness
v Less than 15 lb paper
v Less than 0.08 mm (0.003 in) paper thickness

Other considerations for forms

Consider the following items, unless Table 22 or Table 23 provides other direction.
v InfoPrint Solutions Company recommends you test the Park function when you intend to run multiple-part
forms. If you notice forms feed problems, try using the Eject function. If using the Eject function is effective,
disable the Park function.
v When your printer is loaded with different forms in the rear and the front tractors, your job (or the operator) can
select the desired source, and alternate between the two paths. The operator must tear off the forms to allow
the printer to change paths.
v See Table 23 for recommended paper weight and thickness.
v For forms stacking convenience, consider ordering and using the optional 4247 printer stand.
1
Rear tractor Front tractor
Appendix B. Supplies, forms, paths, & environmental considerations
2
Comments
284