Running The Test And Diagnostic (T&D) Programs - InfoPrint 4247 Z03 Maintenance Information

Print Error Log
Count Code Description
00007 *002 FORMS JAMMED FRONT
00001 051 MACHINE CHECK
00003 020 FORMS JAMMED REAR
00001 055 MACHINE CHECK
00000 000
00000 000
00000 000
00000 000
Figure 3. Sample of Error Log
Print Usage Metrics
Power-on Hours
Power-on Cycles
Fast Draft Characters
DP Characters
DP Text Characters
NLQ Characters
Number of Barcodes
Pages with Graphics or Images
Figure 4. Sample of Print Usage Metrics
Running the test and diagnostic (T&D) programs
The T&D program can be run in two modes: Single Test Mode or Automatic Test Mode. Single Test Mode is used
to run individual tests, for example, to perform an adjustment or print a print test. Automatic Test Mode, which runs
all the tests sequentially, is used to verify correct printer operation. Automatic mode requires manual intervention
for several of the tests.
1. Power off the printer.
2. Remove all paper from the paper paths.
Tests T&D09 through T&D14 and T&D18 can perform paper path sensor tuning. If sensors are tuned with
paper in the path, paper will not feed correctly.
84
136
42
1,541,409
131
0
0
0
88
Chapter 2. Diagnostics