Table of Contents
Advertisement
Slot assembly
DANGER
<1-13> Do not connect or disconnect a communication port, a teleport, or any other connector during an
electrical storm.
DANGER
<1-14> Switch off printer power and unplug the printer power cord before connecting or disconnecting a
communication port, a teleport, or other attachment connector.
Attention:
This is an ESD sensitive area. See Electrostatic discharge (ESD) procedures before working with
parts that are sensitive to ESD.
1. Remove the Controller Board.
2. Remove the Rear Cover.
3. Remove the Metal Protector (for the Engine Board and Power Supply).
4. Unscrew the six screws on the top, lateral, and rear sides of the slot assembly.
Note: Using a screwdriver remove the screw that attaches the Slot Assembly to the Metal Insert by passing
the screwdriver through the access hole. This screw is located at the opposite side of the Slot
Assembly from the access hole. See the following figure.
Chapter 5. Removals, service checks and adjustments
191
Advertisement
Chapters
Table of Contents
