T&D14-Fanfold Form Printout Test - InfoPrint 4247 Z03 Maintenance Information

8. Press the CANCEL PRINT. The following message will display:
T&D13 TEAR-OFF LINE ADJ
STORE?
9. If the tear-off adjustment is correct, press the SET TOP OF FORM key to store the tear-off position.
If the tear-off adjustment is not correct, press the LOAD/EJECT key, and return to step 7 on page 104.
10. If the optional front tractor is installed, install the paper in the optional front tractor, and repeat the above
procedure to adjust the tear-off line for the optional front tractor.
11. If an error message is displayed, go to T&D error messages and actions.
12. The test completed successfully if the paper feeds back into the printer and the present test is displayed
again.
T&D14—Fanfold form printout test
Note: Use this test to check print quality, print wires, printhead wire shifter (18-wire printhead only), carrier
movement, paper feed, line skew, and bidirectional (vertical) alignment. See Print quality service checks for
symptoms, and see Figure 16 for an example of a print sample.
1. Display:
T&D14 FANFOLD FORM PRINT
RUN TEST?
2. Press SET TOP OF FORM to execute test. Press LOAD/EJECT to skip test.
3. If fanfold paper is not loaded, the printer will display:
T&D14 FANFOLD FORM PRINT
LOAD PAPER
4. Install at least two fanfold forms (11- or 12-inch) in the rear tractor assembly (see Paper path
nomenclature), and press the SET TOP OF FORM key.
YES
YES NO
NO
106
Chapter 2. Diagnostics