T&D08-Lan Interface Test; T&D09-Sensor Tune/Ribbon Test - InfoPrint 4247 Z03 Maintenance Information

2. Press SET TOP OF FORM to execute test. Press LOAD/EJECT to skip test.
3. If an error message is displayed, go to "T&D error messages and actions" on page 112.
4. The test completed successfully if the present test is displayed again. Press LOAD/EJECT to skip to the next
test.
T&D08—LAN interface test
T&D08 LAN INTERFACE TEST
RUN TEST?
1. Press SET TOP OF FORM to execute test. Press LOAD/EJECT to skip test.
2. If an error message is displayed, go to "T&D error messages and actions" on page 112.
3. The test completed successfully if the present test is displayed again. Press LOAD/EJECT to skip to the next
test.
T&D09—Sensor tune/ribbon test
Note: Ensure that there is no paper in any paper path. This test does the paper path sensor tuning but does not
tune the tractor jam sensors, as these sensors are not adjustable.
1. Display:
T&D09 SENSOR TUNE/RIBBON
RUN TEST?
2. Press SET TOP OF FORM to execute test. Press LOAD/EJECT to skip test.
3. The next part of this test is forms path sensor tuning.
Important
The forms path sensors were tuned. The tuning must be done with all paper removed. If paper is
installed, remove the paper and repeat T&D09
YES NO
YES NO
95
Chapter 2. Diagnostics