Loading Code Though The Ethernet Port - InfoPrint 4247 Z03 Maintenance Information

4. Connect a standard parallel cable between your computer's LPT1 port and the printer.
5. Press and hold the printer START and STOP keys and power on the printer.
6. Release the keys after RELEASE KEYS displays and WAITING CODE will display with all LEDs flashing.
7. In a DOS window type: copy drive:\directory\filename.bin lpt1: /b <enter>
For example: copy c:\temp\4247-Z03_0009.bin lpt1 /b
8. While the printer code is being received RECEIVING CODE displays.
9. While the printer code is being updated ERASING SECT.XX followed by WRITING SECT.XX displays.
10. After the code download completes and is verified, CODE OK displays before the printer automatically
reboots and STARTING UP displays.
Note: If "NVM CHANGE" displays, this means that all of the printer configuration settings have been
restored to factory defaults.
11. Printout the printer configuration menus again (as described above) and label them "new".
12. Compare the old and new configuration printouts and restore the printer's configuration as needed.

Loading code though the Ethernet Port

Follow these instructions to FTP printer code to a network attached printer. The instructions assume that you are
nearby the printer and can access the operator panel.
1. Printout the printer configuration menus to ensure original settings can be restored at the end of this
procedure. Label this set of configurations as old.
Note: Loading new code won't change any of the printer's network interface settings (IP, subnet mask,
gateway addresses), but other user defined configuration settings can be reset to factory default
values.
a. Load forms in the front tractor.
b. Press the STOP key to make the printer NOT READY.
|
c. Press the TEST key and the printer displays OPERATOR PRINT TESTS.
d. Press the SCROLL/MICRO ↓ key until Print Custom Sets displays below OPERATOR PRINT TESTS.
e. Press the ENTER key and wait for the configuration to print.
Appendix C. Firmware Downloading
293