Table of Contents
Advertisement
Carriage assembly
CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes for parts in this area to cool before
handling.
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Cover group.
3. Remove the Printhead.
4. Remove the Automatic forms thickness adjust (AFTA) assembly.
5. Remove the Paper bail assembly.
Then:
Attention:
Use care not to damage the encoder strip.
6. Loosen the carriage belt clamp screws (3) and remove the
belt from the clamp.
Attention:
In the next step, look for small sheetmetal wear
surfaces may be present straddling the side frame where the
carriage shaft is resting; they are easily lost.
Chapter 5. Removals, service checks and adjustments
196
Advertisement
Chapters
Table of Contents
