InfoPrint 4247 Z03 Maintenance Information page 97

If the AFTA mechanism is malfunctioning or not repeatable, perform the "Print Head Gap Service Checks" on page
142.
Display:
T&D10 AFTA CALIBRATE
AFTA CALIBRATE
Since two tractor configurations are possible (one tractor installed or two tractors installed) the procedure followed
depends on which configuration the printer is in. For the one tractor installed configuration (default tractor only),
the display is:
T&D10 AFTA CALIBRATE
USER FRONT FF?
If YES:
T&D10 AFTA CALIBRATE
LOAD PAPER
Load 20 lb (80 g/m²) fanfold paper in front tractor and press SET TOP OF FORM to execute calibration using
fanfold forms.
If NO:
T&D10 AFTA CALIBRATE
INSERT SING. SHEET ON UP
Manually load a single sheet of 20 lb (80 g/m²) paper into the upper paper path. Locate the hole in the Base
frame and black taped area of the Guide Assembly. Insert paper into this area of the upper tractor path.
(Approximately 4 1/2 inches inboard from the left edge of the tractor assembly.)
YES NO
97
Chapter 2. Diagnostics