Carriage Drive Belt - InfoPrint 4247 Z03 Maintenance Information

Carriage drive belt

CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes for parts in this area to cool before
handling.
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Cover group.
Print Head
Screws
Ribbon
Lift
Connector
Cable Clamp
Screw
Then:
3. Remove the ribbon.
4. Move the printhead to the center of the printer.
5. Remove the printhead cable clamp.
6. Remove the printhead screws.
7. Disconnect the encoder cable, if necessary, from the
printhead connector.
Do not disconnect the other cables.
Place the printhead by the carriage.
Chapter 5. Removals, service checks and adjustments
199